Sensible Kitchen Designs For Rental House

Your own home is your particular place, whether or not it’s rented or owned by you. Nevertheless, in terms of the interiors of a rental dwelling, there are some limitations that you simply want to remember. You can’t make any everlasting adjustments to the house, and also you wish to keep away from something that will require portray and development work while you plan to maneuver.

Crucial house in any house is the kitchen. If you wish to redecorate your kitchen or make it extra practical, listed here are some sensible kitchen designs for rental properties.

Creating Extra Storage Area

One of the frequent complaints amongst tenants who transfer right into a rental house is the dearth of space for storing within the kitchen. In a rented dwelling, you can’t make new cupboards as they’re very excessive on funding.

To create a practical kitchen for a rental dwelling, storage is essentially the most essential issue. It’s a good suggestion to buy wall mounted cabinets or cupboards. They can be utilized to retailer meals jars, crockery and different objects. These cabinets enable quick access if you end up cooking and are extraordinarily straightforward to scrub as effectively.

It’s also possible to

Read more

DIY Suggestions for Putting in Cement Backerboard

Man laying floor tiles.

When tiling over plywood, it’s best to at all times put down a layer of cement backer board first, which is able to present the mandatory assist for the tile. Listed below are eight vital steps to bear in mind when putting in cement backer board:

  1. Test the plywood subfloor for any motion and squeaks. Use 2 inch drywall screws to lock down any hassle spots, driving the screws by way of the plywood and into the ground joists under.
  2. Use a notched trowel to unfold thin-set mortar over the plywood subfloor.
  3. Lay the cement backer board into the thin-mortar, ensuring to overlap any seams within the plywood subfloor by at the very least 4 inches.
  4. Fasten the backer board utilizing an impression driver and backer board screws; area the screws 4 inches aside across the perimeter of the backer board sheet and eight inches aside throughout the middle.
  5. Go away a one-eighth inch hole between the backer board sheets and stagger the sheets in order that 4 corners don’t meet at a single intersection.
  6. Cowl the seams between the backer board sheets with fiberglass mesh tape.
  7. Unfold a skinny layer of thin-set mortar over the taped joints.
  8. As soon
Read more